Preferred Path Loop-Free Alternate (pLFA)
draft-bryant-rtgwg-plfa-04
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Stewart Bryant , Uma Chunduri , Toerless Eckert | ||
| Last updated | 2022-11-10 (Latest revision 2022-05-09) | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Fast re-route (FRR) is a technique that allows productive forwarding to continue in a network after a failure has occurred, but before the network has has time to re-converge. This is achieved by forwarding a packet on an alternate path that will not result in the packet looping. Preferred Path Routing (PPR) provides a method of injecting explicit paths into the routing protocol. The use of PPR to support FRR has a number of advantages. This document describes the advantages of using PPR to provide a loop-free alternate FRR path, and provides a framework for its use in this application.
Authors
Stewart Bryant
Uma Chunduri
Toerless Eckert
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)